This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Impresión 3D a partir de modelo de Metashape
#1
Intento imprimir un modelo de terreno creado con Metashape, pero no se como incluir una pieza sólida que soporte dicho modelo. Alguien podría guiarme en este aspecto??? (me estoy volviendo loco con el tema....)
Gracias, y perdón si no es el sitio adecuado donde plantear esta duda...
  Responder