This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Anycubic Mono 6k
#1
Buenas!

Estoy probando esta impresora, y poniendo a punto sus parámetros. Alguna vez parece que debo tener algún parámetro mal elegido, en especial en los soportes, donde me ha fallado más de una pieza.
¿Alguien ha probado parámetros de laminado y de soportes que funcionen bien?
Imagino que los mismos parámetros de otra Anyucubic de la serie Photon podrían ser útiles, por ejemplo, en los soportes.

Gracias de antemano.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Error RERF Photon Mono X LogiCat 0 181 19-02-2023, 07:56 PM
Último mensaje: LogiCat
  Opiniones Anycubic Photon Mono 4K defalt 0 524 04-05-2022, 04:44 PM
Último mensaje: defalt
  Pantalla con rayas cuando se actualiza. photon x mono Sufinegro 5 1,640 30-04-2022, 09:55 PM
Último mensaje: joselarralde
  mi impresora P Mono X no imprime en el centro larryelman 4 865 19-03-2022, 10:09 PM
Último mensaje: larryelman
  Anicubic photon mono x firmware mrg007 4 2,023 20-02-2022, 05:49 PM
Último mensaje: Alejopaisa