This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Driver 8825
#1
Hola, según el fabricante hay 3 maneras distintas de configurar el driver para 1/32 de paso, lo que quiero saber es si hay alguna diferencia entre ellas?, mas allá de ahorrar algunos jumpers. Saludos
  Responder
#2
Hola, a efectos prácticos no hay ninguna diferencia entre esas tres configuraciones.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Pregunta CONSULTA Cambiar driver a una Impresora de resina gerard 0 264 21-11-2021, 09:41 PM
Último mensaje: gerard
  CONSULTA Cambio driver Sapphire Pro rgl3dprint 5 1,555 13-11-2020, 09:24 AM
Último mensaje: rgl3dprint
  Diferencias de configuracion segun driver para el mismo motor 21Curiosos 2 1,076 24-04-2020, 08:21 PM
Último mensaje: 21Curiosos
  Posible Driver Estropeado Juanan_AB 3 1,233 19-11-2019, 11:48 PM
Último mensaje: Juanan_AB
  CONSULTA Kit Ramps 1.4 Driver A4988 Arduino Mega Quemado JuanCPineda2010 3 2,058 25-04-2019, 01:02 AM
Último mensaje: Simemart